Page 20 Page 21 – Fault-tolerant cabling connections showi Hp storageworks isl trunking v3. Gather fault information, including using system LEDs [see. Hp storageworks advanced performance monitoring v3. Options for performing basic. From your network administrator, obtain an IP address, subnet mask, and gateway address for controller A, and.

Uploader: Zologor
Date Added: 13 September 2017
File Size: 62.55 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 22931
Price: Free* [*Free Regsitration Required]

HP StorageWorks P2000 – Connecting to and Configuring

Windows customers should locate the downloaded device driver described in. MSA controllers provide many ways to isolate faults. From your network administrator, obtain an IP address, subnet mask, and gateway address for controller A, and.

Page 51 – If the controller has failed or does not Hp storageworks fabric os v3. By pressing ‘print’ button you will print only current page. This section presents the basic methodology used to locate faults within a storage system, and to identify the associated Ma Units FRUs affected. If the default IP addresses are not compatible with your network, you must set an IP address for each network port using. Page 20 Page 21 – Fault-tolerant cabling connections showi For Linux systems, see.


Complain wrong Brand wrong Model non readable. Enable the CLI port for subsequent communication. Page 14 – Drive enclosures Page 15 – Supercapacitor pack Page 16 – Installing the enclosures Page 17 – Connecting controller and drive enclosur Page 35 – Connecting two storage systems for Remot Page 57 – Resolving voltage and temperature warnin As noted in “Basic operation” page 49u se the SMU to configure and provision the system upon completing the hardware installation.

If any component has a problem, the system health will be Degraded, Fault, or Unknown. Page of 81 Go.

Connecting A Usb Cable To The Cli Port – Hp MSA User Manual [Page 39]

If you encounter problems communicating with the port after cabling your computer to the USB device, you may need to either download a device driver Windowsor set appropriate parameters via an operating system command Linux.

Hp msa quick start instructionsjune 6 pages. Hp storageworks fabric watch v3. The basic fault isolation steps are listed below:.

Solved: Driver for cable CLI for MSA – Hewlett Packard Enterprise Community

Network ports on controller module A and controller module B are configured with the following factory-default IP settings:. Management Port IP Address: Comments to this Manuals Your Name. The SMU enables you to monitor the health of the system and its components.


Page 34 – Connecting two storage systems for Remot Page 54 – Replication setup and verification Page 55 – Diagnostics for replication setup: Use of any option four options are described below is not mutually-exclusive to the use of another option.

As part of this process, configure and enable event notification so the. Options for performing basic.

Hewlett Packard Enterprise CABLE CLI USB

See “Connecting to the controller CLI port” page 43 for more information. Use the CLI commands described in the steps below to set the IP address for the network sub on each controller module.

Don’t show me this message again. Review event logs [see.